I'm trying to capture a gargoyle, figured it was a good test, the closest object I have to a rock
My setup is a foldio360 turntable and tent ala https://3dscanexpert.com/review-fold...hotogrammetry/
I tried to capture it several times, each time 3DF Zephyr would not put the pictures in a ring around the model. Instead they would be clumped together to one side (see attached)
Could you take a peek at my photos and see if there's anything I'm doing that's obviously wrong? Or could be done better?
When I throw the same set of photos at Recap (well, 100 of them, I have a student license) it was able to produce this https://sketchfab.com/models/053d961...0c3db621c521fb
I hope direct comparisons are not frowned upon, just trying to give as much info as possible so that I can learn what I'm doing wrong!
Thanks in advance =)
My setup is a foldio360 turntable and tent ala https://3dscanexpert.com/review-fold...hotogrammetry/
I tried to capture it several times, each time 3DF Zephyr would not put the pictures in a ring around the model. Instead they would be clumped together to one side (see attached)
Could you take a peek at my photos and see if there's anything I'm doing that's obviously wrong? Or could be done better?
When I throw the same set of photos at Recap (well, 100 of them, I have a student license) it was able to produce this https://sketchfab.com/models/053d961...0c3db621c521fb
I hope direct comparisons are not frowned upon, just trying to give as much info as possible so that I can learn what I'm doing wrong!
Thanks in advance =)
Comment