How do I re-run a reconstruction attempt?

[gneisslab]

I am unable to figure out how re-run the Reconstruction phase of the processing.

I can see on the drop-down from the Workflow tab how to re-run the dense cloud and mesh reconstruction, but I dont see how I can re-run the Reconstruction without starting an entirely new project.

I'm sure it's obvious but what am I missing?

[cam3d]

gneisslab - You can select the cameras you want to re-run in the project panel and start a new project this way (so it's not entirely new) but you can't generate multiple sparse clouds in a single workspace/project.

[gneisslab]

Thanks! I will give it a go